"Application Has Failed to Start Because Framedyn.dll Was Not Found" Error Message When You Open the System Properties Dialog Box
View products that this article applies to.
Article ID : 319114
Last Review : November 4, 2003
Revision : 1.0
This article was previously published under Q319114
On This Page
SYMPTOMS
CAUSE
RESOLUTION
Replace the Framedyn.dll File
Verify System Variables
SYMPTOMS
When you double-click System in Control Panel, or when you right-click My Computer and then click Properties, you may receive the following error message:
rundll32.exe - Unable To Locate Component
This application has failed to start because framedyn.dll was not found. Re-installing the application may fix this problem.
Back to the top
CAUSE
This behavior can occur if either of the following conditions is true: • The %SYSTEMROOT%\System32\Wbem\framedyn.dll file is missing or damaged.
-or-
• The Windows Path environment variable does not point to the %SYSTEMROOT%\System32\Wbem folder.
Back to the top
RESOLUTION
To resolve this issue, use both of the following methods.
Back to the top
Replace the Framedyn.dll File
1. Click Start, and then click Run.
2. In the Open box, type %systemroot%\system32\dllcache, and then click OK.
3. Right-click framedyn.dll, and then click Copy on the shortcut menu that appears.
4. Click Start, and then click Run.
5. In the Open box, type %systemroot%\system32\wbem, and then click OK.
6. On the Edit menu, click Paste. If you are prompted to replace the existing file, click Yes.
Back to the top
Verify System Variables
1. Click Start, right-click My Computer, and then click Properties on the shortcut menu that appears. If you receive the following error message, click OK:
rundll32.exe - Unable To Locate Component
This application has failed to start because framedyn.dll was not found. Re-installing the application may fix this problem.
2. In the System Properties dialog box, click the Advanced tab.
3. Click Environment Variables.
4. Under System variables, click Path, and then click Edit.
NOTE: If no Path variable is listed, click New. In the Variable name box, type Path.
5. In the Variable value box, type the following:
%SystemRoot%\system32;%SystemRoot%;%SystemRoot%\System32\wbem
6. Click OK three times (each time that you have the option).