Hi Spybot crew and fellaz.
I've been using Spybot 1.3 all this time and thanks for the great simple to use program and constant updates, very nice.
I just decided to install Spybot 1.4 (NOT that I was having problems with 1.3), and I downloaded and installed the updates.
However, when I check-for-problems, on the status bar below where it usually shows the checking, it just shows "unknown" for about 5 seconds, then says "0 problems found" message, whereas 1.3 used to take few minutes and not 5 seconds, and actually displayed in the status bar the searching.
Am I missing something?? Does anyone else experience this? As I'm pretty positive it isn't really scanning at all.
Thanks all, appreciate it,
Ash.