Antiverminizer... no startup

[dclingman]

I recieved the antiverminizer stuff via you-tube... (bad codec install)

I went to add/remove programs and uninstalled antiverminizer. I then restarted the computer.

All that happened was a blinking curser for a moment after the boot screen and then the windows start-up options.

Safe-mode

Last known good config

Normal

I chose any of the three and it reboots again and comes back to this screen.

I cannot get to safe by F8
I cannot get to system restore by F10.

My restore files are on a hidden partition of the drive.

I have a slave drive with WinXP S1 on it.

Should I swap my master and slave drive to get start-up..?

How can I fix this?

-D

[dclingman]

Turns out my slave drive was causing the no startup issue.

Still have antivermins problem... will try delete steps here.

[pskelley]

Welcome to the forum, if you still need help and are not receiving it elsewhere, it appears you have missed some important instructions our administrator has posted at the top of the forum,
especially this: "BEFORE you POST" -Preliminary Steps
http://forums.spybot.info/showthread.php?t=288

Please read and follow all instructions and post all required logs or reports, anything less will slow your process.

Use "Post Reply" to post the information in the instructions and stay in the same topic.

Thanks

[tashi]

This topic has been archived.

If you need it re-opened please send me a private message (pm) and provide a link to the thread. Applies only to the original topic starter.