Can't read memory

[whocando]

Hi,

Has anyone else had the following problem.

The instruction at "0x01a540c2" referenced memory at "0x06dee120". The memory could not be read.

note: the first hex number above changes.

after hitting OK the following pops up.

Runtime error 216 at 01A540C2

note: the hex number above changes.

This error occurs after a Spybot scan has finished and I close the program.

This only happens to Spybot.

I have ver 1.6.3.51 installed.

Regards

[NotGeordie]

http://forums.spybot.info/showthread.php?t=50441

See the above thread. Lots of people have encountered the problem recently. I'll bet that your contribution to the solution might help. Read all the posts.

[whocando]

Thanks NotGeordie, I did search before I posted.

So it's not just me.

[NotGeordie]

:oops:

Sorry, I didn't mean to infer that you hadn't done your homework. I meant to suggest that you read all the posts in that thread so that you would get the picture as it's developed thus far.

No, you're not alone.

Je m'excuse.

[whocando]

Hi NotGeordie,

You missunderstood my response to your link suggestion.

You don't need to apologist. I meant that I had searched :-), thankyou. I didn't mean I HAD SEARCHED!.

I find texting/blogs so difficult to show emotion on LOL

Keep up the good work/suggestions.

By the way, you have private mail turned off.

Regards

[spybotsandra]

Hello,

Please run Spybot - Search & Destroy and switch to "Advanced mode" via the menu bar item "Mode" and select "Settings" --> "File Sets" in the left bar. There please untick the checkboxes in front of "trojansc" and "malwarec.sbi".
Now run Spybot and see if you still get any error messages.
Thanks. :)

You will also find a thread about this problem in our forum: http://forums.spybot.info/showthread.php?t=50441&page=8

Best regards
Sandra
Team Spybot