Svchost.exe bad Image

[tysonandmisty]

I cannot log on to my computer . I keep getting the above message and the following and then my computer freezes
"The application or DLL C:\windows\system32\digiwet.dll is not a valid windows image. Please check this against your installation diskette"

How do i get started again please

Bob

[pskelley]

Welcome to Safer Networking, I wish to be sure you have viewed and understand this information.
"BEFORE you POST" (READ this Procedure before Requesting Assistance) http://forums.spybot.info/showthread.php?t=288
All advice given is taken at your own risk.
Please make sure you have read this information so we are on the same page.

Bob, I can not even say I can help at this point because of lack up posted information. Posted above and pinned (sticky) to the top of this forum are the directions. If you read and follow them, and post the required HijackThis log that we start with, I will take a look.

I can tell you the item you describe is like very dangerous, see this:
http://www.threatexpert.com/report.a...0e2e2badebe295
Since it is a Backdoor trojan, you should view this information:
How Do I Handle Possible Identify Theft, Internet Fraud and CC Fraud?
http://www.dslreports.com/faq/10451
When Should I Format, How Should I Reinstall
http://www.dslreports.com/faq/10063

Thanks...Phil

[pskelley]

Due to the lack of feedback this Topic is closed.

If you need this topic reopened, please request this by sending the moderating team
a PM with the address of the thread. This applies only to the original topic starter.

If it has been four days or more since your last post, and the helper assisting you posted a response to that post to which you did not reply, your topic will not be reopened. At that point, if you still require help, please start a new topic and include a fresh HijackThis log and a link to your previous thread.

If it has been less than four days since your last response and you need the thread re-opened, please send me or your helper a private message (pm). A valid, working link to the closed topic is required.

Everyone else please begin a New Topic.