Automatization of S&D 2

[RadoR]

Hi,

I used to use single command in S&D 1.6.x for "complete upkeep": SpybotSD /taskbarhide /autoupdate /autoimmunize /autocheck /autoclose

I learned that there's no such posibility in S&D 2 or am I wrong?

I tried to use SDUpdate /autoupdate /silent /taskbarhide and SDImmunize /immunize /silent /taskbarhide /autoclose but neither of the two commands worked as I expected.

It seems that SDUpdate has been checking status instead of running update, SDImmunize has done nothing and neither of them were "silent".

Are these switches and such unattended behavior reserved for professional version or did I something wrong?

[Zenobia]

I'd just installed Spybot 2.0 recently,so I'm not totally up to speed.But here is what I could dig up on the Spybot page.

On this page,there is a red x beside Command Line Parameters:
http://www.safer-networking.org/private/
And this page says it depends on the installed version of Spybot:
http://www.safer-networking.org/faq/...t-can-be-used/

[RadoR]

Thanks, Zenobia, first link clarified everything.

I think I stick to v.1.6.2.

[Zenobia]

You're welcome.