Hi,
I have two questions regarding the hosts file:
1) Can I manually add an entry to it?
2) Will the line that I manually added, disappear the next time Spybot updates the immunizations?
Thanks!
--JorgeA
Hi,
I have two questions regarding the hosts file:
1) Can I manually add an entry to it?
2) Will the line that I manually added, disappear the next time Spybot updates the immunizations?
Thanks!
--JorgeA
Hello JorgeA,
Yes, one explanation: http://forums.spybot.info/showthread.php?t=61701
From the same thread, Hope that helps.
Microsoft MVP Reconnect 2018-
Windows Insider MVP 2016-2018
Microsoft Consumer Security MVP 2006-2016
tashi,
Thank you very much for the reply -- you've provided all the information that I was looking for!
--JorgeA
Cheers.
Microsoft MVP Reconnect 2018-
Windows Insider MVP 2016-2018
Microsoft Consumer Security MVP 2006-2016
tashi (or anybody else who can answer this),
OK, so I went to modify the Hosts file to add a couple of lines. I tried to do this in Notepad. When I went to save the file, I got a pop-up box that said, "Cannot create the C:\Windows\System32\drivers\etc\hosts file. Make sure that the path and file name are correct."
Huh? I was in the right place, at least I seemed to be. Maybe there is write protection on the hosts file?
Even more confusingly, when I went to close Notepad, it actually gave me a new box asking if I wanted to save the changes that, just before, I had been prohibited from saving.
I think I'll leave this alone for the time being.
What do you think?
--JorgeA
P.S. I tried the approach offered by Microsoft here, but it didn't help -- I still got the same error message.
Last edited by JorgeA; 2011-12-20 at 02:20.
I took too long to find the solution, so I had to write it in a separate post:
The key is that you need to go into the Hosts file's Properties, and uncheck the "Read-only" attribute. Having done that, you can then open Notepad (still as an administrator), make the changes, and finally get to save them.
At the end, don't forget to change the hosts file's attribute back to "read-only."
Hope this helps somebody trying to do the same thing.
--JorgeA