=PAUSE= option

M

mateusz

New member
Software Version
5.1.1
Operating System
Windows 10 (64 bit)
I have almost full protection enabled — 662 out of 664 options are turned on. However, when I disable and re-enable protection, either too few or too many options get enabled automatically.

Why can’t I save my own custom preset?

Also, why is there no simple “Pause” button, or at least a way to pause protection by vendor? For example, if I need to update Microsoft Office, I may temporarily need to allow certain IPs in the etc/config settings. Right now, pausing the software is unnecessarily difficult.

P.S. If the exact software version is required for forum posts, the version number should be visible directly in the main window instead of being hidden under “About”. Also, there’s a message saying “please match the exact format”, but the required format itself is not explained anywhere.

There are quite a few UI/UX issues here.
 
My apologies for the delay in replying.

Are you saying that after re-enabling protection again, not all entries are re-immunized correctly and that is inconsistent with the number of entries that are re-Immunized?

Thank you for your suggestions regarding the being to be able to pause protection. I will pass this on to our development team so that they can consider this for a later version.

Can you please a screenshot for the message you are referring to that says “please match the exact format”?

Thank you :)
 
You must log in or register to reply here.
Back
Top